Inspecting Straight Grab Bar - all sizes

  • Step 1 - Open carton
  • Step 2 - Locate grab bar and hardware pack
  • Step 3 - Carefully remove grab bar
  • Step 4 - Cut a small slot through protective film to expose sleeve
  • Step 5 - Repeat on opposite side
  • Step 6 - Pull protective film up so grab bar can be inspected
  • Step 7 - Remove bushing from hardware pack, both will be required for inspection
  • Step 8 - Locate rough-in fastener
  • Step 9 - Remove stabilizer for inspection
  • Step 10 - Remove thumb screws for inspection
  • Step 11 - Align bushing with grab bar and slip together
  • Step 12 - As illustrated above, inspect to ensure bushing threads are clearly visible through grab bar sleeve. After inspection carefully repackage.